Refer to the exhibit. After an engineer configures an EtherChannel between switch SW1 and switch SW2, this error message is logged on switch SW2:
SW2#
09:45:32: %PM-4-ERR_DISABLE: channel-misconfig error detected on Gi0/0, putting Gi0/0 in err-disable state 09:45:32: %PM-4-ERR_DISABLE: channel-misconfig error detected on Gi0/1, putting Gi0/1 in err-disable state Based on the output from switch SW1 and the log message received on switch SW2, what action should the engineer take to resolve this issue?
- A. Configure the same protocol on the EtherChannel on switch SW1 and SW2.
- B. Define the correct port members on the EtherChannel on switch SW1.
- C. Correct the configuration error on Interface Gi0/0 on switch SW1.
- D. Correct the configuration error on Interface Gi0/1 on switch SW1.
The post After an engineer configures an EtherChannel between switch SW1 and switch SW2, this error message is logged on switch SW2: appeared first on Majanto.