An engineer configured the New York router with static routes that point to the Atlanta and Washington sites. Which command must be configured on the Atlanta and Washington routers so that both sites are able to reach the loopback2 interface on the New York router?

By | November 19, 2022

Refer to the exhibit. An engineer configured the New York router with static routes that point to the Atlanta and Washington sites. Which command must be configured on the Atlanta and Washington routers so that both sites are able to reach the loopback2 interface on the New York router?

  • A. ipv6 route::/0 Serial 0/0/0
  • B. ipv6 route::/0 Serial 0/0/1
  • C. ipv6 route:0/0 Serial 0/0/0
  • D. ip route 0.0.0.0 0.0.0.0 Serial 0/0/0
  • E. ipv6 route::/0 2000::2
Answer: Option A.
Explanation: 

Section: IP Connectivity
Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_pi/configuration/xe-3s/iri-xe-3s-book/ip6-route-static-xe.html#GUID-85796C3A-3143-4DF7-B9D0-8EC87D0DB08B

The post An engineer configured the New York router with static routes that point to the Atlanta and Washington sites. Which command must be configured on the Atlanta and Washington routers so that both sites are able to reach the loopback2 interface on the New York router? appeared first on Majanto.

Leave a Reply

Your email address will not be published. Required fields are marked *