A. metric B. priority C. circuit type D. hello interval Answer: Option D. Explanation: No answer description available for this question. Show AnswerDiscussion The post Which output from the show isis interface command helps an engineer troubleshoot an IS-IS adjacency problem on a Cisco IOS-XR platform? appeared first on Majanto.
Compare different features between OSPFv2 and OSPFv3. Drag and drop the descriptions of OSPF from the left onto the correct OSPF versions on the right. Select and Place: Answer: Explanation: No answer description available for this question. Show AnswerDiscussion The post Compare different features between OSPFv2 and OSPFv3. Drag and drop the descriptions of OSPF from the left… Read More »
An engineer is troubleshooting end-to-end customer traffic across an MPLS VPN service provider network. Which tasks should the engineer use to solve the routing issues? Drag and drop the table types from the left onto the most useful troubleshooting tasks/router types on the right. (Not all options are used.) Select and Place: Answer: Explanation: No answer description available… Read More »
A. Segment routing must first be enabled under then routing process and then globally B. Segment routing must first be enabled globally and then under the routing process C. Segment routing can be enabled only under the routing process D. Segment routing can be enabled only globally Answer: Option B. Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/seg_routing/configuration/xe-16-6/segrt-xe-16-6-book/sr-ospfv2-node-sid.html Show AnswerDiscussion The post Which… Read More »
Refer to the exhibit. An engineer is addressing an IS-IS design issue which is running within the topology. All links are running on FastEthernet, except the link between R5 and R4, which is Gigabit Ethernet. Which statement about the design is true? A. R4 prefer to reach R5 using R1 as the next hop B. All links have… Read More »
A. The receiver explicitly requests its desired traffic from the RP on the shared tree. B. The receiver explicitly requests traffic from a single source, which responds by forwarding all traffic. C. The RP on the shared tree floods traffic out of all PIM configured interfaces. D. The receiver explicitly requests traffic from each desired source, which responds… Read More »
Refer to the exhibit. Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed. Which statement about this configuration is true? A. Router 1 must define an explicit path to router 2 B. Router 1 and router 2 must define the RSVP bandwidth reserved on the physical interfaces C.… Read More »
Refer to the exhibit. An engineer has successfully fixed BGP peering issue. R1 has an established eBGP peering with R2 and R3. Which mechanism should the engineer apply in order to steer the traffic correctly? A. The MED attribute can be applied on R2 to influence R1 to use it as the primary path. B. The local preference… Read More »
A. All mapped multicast MAC addresses begin with 0x0100.5E B. The router performs the mapping before it hands the packet off to a switch C. All multicast MAC addresses end with 0x0100.5E D. The mapping process may generate overlapping addresses, which can cause receivers to receive unwanted packets E. All destination MAC addresses begin with an octet of… Read More »
Refer to the exhibit. A customer reports that Host-1 is failing to receive streaming traffic from the IPTV source. The engineer has confirmed that hosts on router R2 are receiving traffic normally and that Host-1 is correctly sending subscription messages to join the IPTV stream. Which action must the engineer take to correct the problem? A. Remove IP… Read More »