Tag Archives: bandwidth

What occurs when a high bandwidth multicast stream is sent over an MVPN using Cisco hardware?

A. The traffic uses the default MDT to transmit the data only if it is a (S, G) multicast route entry. B. A data MDT is created to if it is a (*, G) multicast route entries. C. A data and default MDT are created to flood the multicast stream out of all PIM-SM neighbors. D. A data… Read More »

Which First Hop Redundancy Protocol should be used to meet a design requirement for more efficient default gateway bandwidth usage across multiple devices?

A. GLBP B. LACP C. HSRP D. VRRP Answer: Option A. Explanation:  No answer description available for this question Show AnswerDiscussion The post Which First Hop Redundancy Protocol should be used to meet a design requirement for more efficient default gateway bandwidth usage across multiple devices? appeared first on Majanto.

EIGRP has been configured on all links. The spoke nodes have been configured as EIGRP stubs, and the WAN links to R3 have higher bandwidth and lower delay than the WAN links to R4. When a link failure occurs at the R1-R2 link, what happens to traffic on R1 that is destined for a subnet attached to R2?

Refer to the exhibit. EIGRP has been configured on all links. The spoke nodes have been configured as EIGRP stubs, and the WAN links to R3 have higher bandwidth and lower delay than the WAN links to R4. When a link failure occurs at the R1-R2 link, what happens to traffic on R1 that is destined for a… Read More »

A router running ISIS is showing high CPU and bandwidth utilization. An engineer discovers that the router is configured as L1/L2 and has L1 and L2 neighbors.Which step optimizes the design to address the issue?

A. Make this router a DIS for each of the interfaces B. Disable the default behavior of advertising the default route on the L1/L2 router C. Configure the router to be either L1 or L2 D. Configure each interface as either L1 or L2 circuit type Answer: Option D. Explanation:  No answer description available for this question. Show… Read More »

An organization is designing a detailed QoS plan that limits bandwidth to specific rates. Which two parameters are supported be the traffic policing feature? (Choose two.)

A. violating B. marking C. shaping D. bursting E. conforming Answer: Option B, C. Explanation:  No answer description available for this question. Show AnswerDiscussion The post An organization is designing a detailed QoS plan that limits bandwidth to specific rates. Which two parameters are supported be the traffic policing feature? (Choose two.) appeared first on Majanto.

An architect must design a solution to connect the two ASs. To optimize bandwidth, the design will implement load sharing between router R6 and router R1. Which solution should the design include?

Refer to the exhibit. An architect must design a solution to connect the two ASs. To optimize bandwidth, the design will implement load sharing between router R6 and router R1. Which solution should the design include? A. Use update-source to specify the Loopback interface. B. Use next-hop-self attributes only for routes that are learned from eBGP peers. C.… Read More »

An engineer must design a QoS solution for a customer that is connected to an ISP over a 1Gbps link with a 100Mbps CIR. The ISP aggressively drops all traffic received over the CIR, which is causing numerous TCP retransmissions. The customer is not using any RTP applications but wants to maximize bandwidth usage up to the CIR. Which QoS solution should the engineer choose?

A. policing B. queuing C. traffic shaping D. policer with markdown Answer: Option C. Explanation:  No answer description available for this question. Show AnswerDiscussion The post An engineer must design a QoS solution for a customer that is connected to an ISP over a 1Gbps link with a 100Mbps CIR. The ISP aggressively drops all traffic received over… Read More »