Tag Archives: EtherChannel

After an engineer configures an EtherChannel between switch SW1 and switch SW2, this error message is logged on switch SW2:

Refer to the exhibit. After an engineer configures an EtherChannel between switch SW1 and switch SW2, this error message is logged on switch SW2: SW2# 09:45:32: %PM-4-ERR_DISABLE: channel-misconfig error detected on Gi0/0, putting Gi0/0 in err-disable state 09:45:32: %PM-4-ERR_DISABLE: channel-misconfig error detected on Gi0/1, putting Gi0/1 in err-disable state Based on the output from switch SW1 and the… Read More »

An engineer is configuring an EtherChannel between Switch1 and Switch2 and notices the console message on Switch2. Based on the output, which action resolves this issue?

Refer to the exhibit. An engineer is configuring an EtherChannel between Switch1 and Switch2 and notices the console message on Switch2. Based on the output, which action resolves this issue? A. Configure more member ports on Switchl. B. Configure less member ports on Switch2. C. Configure the same port channel interface number on both switches. D. Configure the… Read More »

Which action resolves the EtherChannel issue between SW2 and SW3?

Refer to the exhibit. Which action resolves the EtherChannel issue between SW2 and SW3? A. Configure switchport mode trunk on SW2. B. Configure switchport nonegotiate on SW3. C. Configure channel-group 1 mode desirable on both interfaces. D. Configure channel-group 1 mode active on both interfaces. Answer: Option D. Explanation:  No answer description available for this question Show AnswerDiscussion… Read More »

Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?

A. active B. on C. auto D. desirable Answer: Option B. Explanation:  Section: Network Access The Static Persistence (or “on” mode) bundles the links unconditionally and no negotiation protocol is used. In this mode, neither PAgP nor LACP packets are sent or received. Show AnswerDiscussion The post Which mode must be used to configure EtherChannel between two switches… Read More »

When configuring an EtherChannel bundle, which mode enables LACP only if a LACP device is detected?

A. Passive B. Desirable C. On D. Auto E. Active Answer: Option A. Explanation:  The LACP is Link Aggregation Control Protocol. LACP is an open protocol, published under the 802.3ad. The modes of LACP are active, passive or on. The side configured as “passive” will waiting the other side that should an Active for the Etherchannel to be… Read More »

Which two commands can you use to configure an actively negotiate EtherChannel? (Choose two.)

A. channel-group 10 mode on B. channel-group 10 mode auto C. channel-group 10 mode passive D. channel-group 10 mode desirable E. channel-group 10 mode active Answer: Option D, E. Explanation:  No answer description available for this question. Show AnswerDiscussion The post Which two commands can you use to configure an actively negotiate EtherChannel? (Choose two.) appeared first on… Read More »