Tag Archives: peer

An engineer must configure HSKP group 300 on a Cisco IOS router. When the router is functional, it must be the active HSKP router. I he peer router has been configured using tie default priority value. Which commard set is required?

A. standby version 2 standby 300 priority 110 standby 300 preempt B. standby 300 priority 110 standby 300 timers 1 110 C. standby version 2 standby 300 priority 90 standby 300 preempt D. standby 300 priority 90 standby 300 preempt Answer: Option A. Explanation:  No answer description available for this question Show AnswerDiscussion The post An engineer must… Read More »

Which command configures the remote peer when the Cisco IOS XR Traffic Controller is used?

A. peer-sync ipv4 192.168.0.3 B. state ipv4 192.168.0.3 C. peer ipv4 192.168.0.3 D. state-sync ipv4 192.168.0.3 Answer: Option D. Explanation:  Reference: https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r6-2/segment-routing/configuration/guide/b-segment-routing-cg-asr9000-62x/b-seg-routing-cg-asr9000-62x_chapter_01001.html Show AnswerDiscussion The post Which command configures the remote peer when the Cisco IOS XR Traffic Controller is used? appeared first on Majanto.

An engineer applied the configuration on R1 to prevent network 192.168.1.0/24 from being propagated outside of area 5. After the change, users have reported they are not able to access any of the application servers that were working before. While checking the routing table of the peer router, the engineer notices R1 stopped propagating any routes outside area 5. Which action must be taken to fix the problem?

Refer to the exhibit. An engineer applied the configuration on R1 to prevent network 192.168.1.0/24 from being propagated outside of area 5. After the change, users have reported they are not able to access any of the application servers that were working before. While checking the routing table of the peer router, the engineer notices R1 stopped propagating… Read More »

Which CLI command does an engineer use to validate that the redundancy peer of a Stateful Switchover pair of controllers is up and connected?

A. rping B. ping C. eping D. mping Answer: Option B. Explanation:  No answer description available for this question. Show AnswerDiscussion The post Which CLI command does an engineer use to validate that the redundancy peer of a Stateful Switchover pair of controllers is up and connected? appeared first on Majanto.