Tag Archives: sends

An engineer must create an EEM applet that sends a syslog message in the event a change happens in the network due to trouble with an OSPF process. Which action should the engineer use? event manager applet LogMessage event routing network 172.30.197.0/24 type all

A. action 1 syslog msg “OSPF ROUTING ERROR” B. action 1 syslog send “OSPF ROUTING ERROR” C. action 1 syslog pattern “OSPF ROUTING ERROR” D. action 1 syslog write “OSPF ROUTING ERROR” Answer: Option A. Explanation:  No answer description available for this question Show AnswerDiscussion The post An engineer must create an EEM applet that sends a syslog… Read More »

What sends the redirect ACL that is configured in the authorization profile back to the Cisco WLC?

A. State attribute B. Class attribute C. Event D. Cisco-av-pair Answer: Option D. Explanation:  Reference: https://community.cisco.com/t5/network-access-control/ise-airespace-acl-wlc-problem/td-p/2110491 Show AnswerDiscussion The post What sends the redirect ACL that is configured in the authorization profile back to the Cisco WLC? appeared first on Majanto.

Which IPv6 address block sends packets to a group address rather than a single address?

A. 2000::/3 B. FC00::/7 C. FE80::/10 D. FF00::/8 Answer: Option D. Explanation:  Section: Network Fundamentals FF00::/8 is used for IPv6 multicast and this is the IPv6 type of address the question-wants to ask. FE80::/10 range is used for link-local addresses. Link-local addresses only used for communications within the local subnetwork (automatic address configuration, neighbor discovery, router discovery, and… Read More »

When PC1 sends a packet to PC2, the packet has which source and destination IP address when it arrives at interface Gi0/0 on router R2?

Refer to the exhibit. When PC1 sends a packet to PC2, the packet has which source and destination IP address when it arrives at interface Gi0/0 on router R2? A. source 192.168.10.10 and destination 10.10.2.2 B. source 192.168.20.10 and destination 192.168.20.1 C. source 192.168.10.10 and destination 192.168.20.10 D. source 10.10.1.1 and destination 10.10.2.2 Answer: Option C. Explanation:  Section:… Read More »

When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A, verifying the IP addresses, and forwarding the packet to PC-B?

Refer to the exhibit. When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A, verifying the IP addresses, and forwarding the packet to PC-B? A. router B. Layer 2 switch C. load balancer D. firewall Answer: Option A. Explanation:  No answer description available for this question. Show AnswerDiscussion The post… Read More »