Tag Archives: Switch1

An engineer is configuring an EtherChannel between Switch1 and Switch2 and notices the console message on Switch2. Based on the output, which action resolves this issue?

Refer to the exhibit. An engineer is configuring an EtherChannel between Switch1 and Switch2 and notices the console message on Switch2. Based on the output, which action resolves this issue? A. Configure more member ports on Switchl. B. Configure less member ports on Switch2. C. Configure the same port channel interface number on both switches. D. Configure the… Read More »

Rapid PVST+ is enabled on all switches. Which command set must be configured on Switch1 to achieve the following results on port fa0/1?

Refer to the exhibit. Rapid PVST+ is enabled on all switches. Which command set must be configured on Switch1 to achieve the following results on port fa0/1? When a device is connected, the port transitions immediately to a forwarding state. The interface should not send or receive BPDUs. If a BPDU is received, it continues operating normally. A.… Read More »