Tag Archives: NAT

An engineer must configure Cisco OEAPs for three executives. As soon as the NAT address is configured on the management interface, it is noticed that the WLC is not responding for APs that are trying to associate to the internal IP management address. Which command should be used to reconcile this?

A. config flexconnect office-extend nat-ip-only disable B. config network ap-discovery nap-ip-only enable C. config flexconnect office-extend nat-ip-only enable D. config network ap-discovery nat-ip-only disable Answer: Option C. Explanation: No answer description available for this question. Show AnswerDiscussion The post An engineer must configure Cisco OEAPs for three executives. As soon as the NAT address is configured on the… Read More »

Which two types of NAT are used in a network? (Choose two.)

A. routed NAT B. static NAT C. multicast NAT D. normal NAT E. dynamic NAT Answer: Option B, E. Explanation: Reference: https://www.dummies.com/programming/networking/cisco/types-of-network-address-translation/ Show AnswerDiscussion The post Which two types of NAT are used in a network? (Choose two.) appeared first on Majanto.

An engineer configured NAT translations and has verified that the configuration is correct. Which IP address is the source IP after the NAT has taken place?

Refer to the exhibit. An engineer configured NAT translations and has verified that the configuration is correct. Which IP address is the source IP after the NAT has taken place? A. 10.4.4.4 B. 10.4.4.5 C. 172.23.103.10 D. 172.23.104.4 Answer: Option C. Explanation: No answer description available for this question. Show AnswerDiscussion The post An engineer configured NAT translations… Read More »

An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any one of three addresses: 192.168.3.1, 192.168.3.2, or 192.168.3.3. Which configuration should be used?

A. B. C. D. Answer: Option D. Explanation: No answer description available for this question. Show AnswerDiscussion The post An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any one of three addresses: 192.168.3.1, 192.168.3.2, or 192.168.3.3. Which configuration should be used? appeared first on Majanto.