A network engineer is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements: * Management protocols must be marked with DSCP AF class 2 with low drop probability. * Monitoring protocols must be marked with DSCP AF class 1 with low drop probability. * All remaining traffic must be… Read More »
Refer to the exhibit. The network engineer who manages ASN 65010 is provisioning a customer VRF named CUSTOMERABC on PE-2. The PE-CE routing protocol is OSPF Internet reachability is available via the OSPF 0 0 0.0/0 route advertised by CE-1 to PE-1 In the customer VRF Which configuration must the network engineer Implement on PE-2 so that CE-2… Read More »
A. Configure a EtherChannel for E-LAN. B. Configure a pseudowire for E-LINE. C. Configure Cisco MPLS TE for use with E-TREE. D. Configure QoS for MPLS and E-ACCESS Answer: Option B. Explanation: No answer description available for this question Show AnswerDiscussion The post An engineer must extend Layer 2 Between two campus sites connected through an MPLS backbone… Read More »
A network engineer must implement SNMPv2 with these parameters: * Enable SNMP community string c1sc0 with read-only permissions. * Enable interface index persistence. Restrict the SNMP community to only the monitoring server with IP address 198.18.19.100/32. * Provide view-only access to ospfIfEntry and ospfNbrEntry. Which configuration must the engineer apply? A. configure terminal access-list 5 permit 198.18.19.100 0.0.0.0… Read More »
Refer to the exhibit. An engineer has started to configure a router for OSPF, as shown Which configuration must an engineer apply on the network so that area 15 traffic from R5 to R1 will prefer the route through R4? A. Place the link between R3 and R5 in a stub area to force traffic to use the… Read More »
A. Configure a distribute list and associate it to the BGP peer interface B. Configure a prefix list and associate it to the BGP peer interface C. Configure a route map and reference it with the redistribute command D. Configure an access list and reference it with the redistribute command Answer: Option C. Explanation: No answer description available… Read More »
Refer to the exhibit. An engineer has started to configure a router for secure remote access as shown. All users who require network access need to be authenticated by the SSH Protocol. Which two actions must the engineer implement to complete the SSH configuration? (Choose two.) A. Configure an IP domain name. B. Configure service password encryption. C.… Read More »
A. Enable communication over TCP port 646 for T-LDP hello messages. B. Enable RSVP-TE FRR on the LDP interface to protect the LDP session between routers. C. Enable LDP session protection on either one of the routers, which allows them to autonegotiate. D. Set the LDP session protection timer on each router to the same value. Answer: Option… Read More »
Refer to the exhibit. CE1 and CE2 require connectivity to the internet through the ISP connected to PE3 What should an engineer configure to complete this task? A. PE2 must be configured to serve as a route reflector for PE3 routes learned from the internet. PE2 then shares the routes with CE1 and CE2. B. CE1 and CE2… Read More »
Refer to the exhibit. A Cisco engineer is implementing gRPC dial-out on an ASR. Receiver 192.168 1.1 will be assigned one of the subscriptions, and it will manage the ASR. Which command is needed to complete the router configuration? A. protocol grpc B. protocol all C. protocol tcp D. protocol any Answer: Option C. Explanation: No answer description… Read More »