Given this class:Which two changes would encapsulate this class and ensure that the area field is always equal to length * heightwhenever the Rectangle class is used? A. Call the setArea method at the beginning of the setLength method. B. Call the setArea method at the end of the setHeight method. C. Change the setArea method to private.… Read More »
Given this class:Which two changes would encapsulate this class and ensure that the area field is always equal to length * height whenever the Rectangle class is used? A. Call the setArea method at the beginning of the setLength method. B. Call the setArea method at the end of the setHeight method. C. Change the setArea method to… Read More »
Refer to the exhibit. An engineer has started to configure a router for OSPF, as shown Which configuration must an engineer apply on the network so that area 15 traffic from R5 to R1 will prefer the route through R4? A. Place the link between R3 and R5 in a stub area to force traffic to use the… Read More »
Refer to the exhibit. Router BRDR-1 is configured to receive the 0.0.0.0/0 and 172.17.1.0/24 networks via BGP and advertise them into OSPF area 0. An engineer has noticed that the OSPF domain is receiving only the 172.17.1.0/24 route and default route 0.0.0.0/0 is still missing. Which configuration must an engineer apply to resolve the problem? A. router ospf… Read More »
Refer to the exhibit. Router 1 and router 2 are running OSPF Area 0. The router logs on both routers show that the LDP link has flapped. Which configuration must the engineer apply to the two routers to implement session protection on the link? A. Router 1(config)# ip cef distributed Router 1(config)# mpls ldp session protection global Router… Read More »
Refer to the exhibit A network engineer is in the process of implementing IS-IS Area 1 and Area 2 on this network to segregate traffic between different segments of the network The hosts in the two new areas must maintain the ability to communicate with one another In both directions. Which additional change must be applied? A. Reconfigure… Read More »
Refer to the exhibit. A network engineer must meet these requirements to provide a connects, solution: The customer connected to Area 2 needs to access the application in Area 1 on the 10.10.10.0/24 subnet The Customer must not have access to the 20.10 30.0/24 subnet. The service provider must make sure that the Area 2 routing database limits… Read More »
A. Reduce channel width from 40 MHz to 20 MHz. B. Reduce AP transmit power. C. Enable Fastlane. D. Increase minimum mandatory data rate. E. Disable 2.4 GHz and use only 5 GHz. Answer: Option B, D. Explanation: No answer description available for this question Show AnswerDiscussion The post Which two methods are used to reduce the AP… Read More »
Refer to the exhibit. Which command when applied to the Atlanta router reduces type 3 LSA flooding into the backbone area and summarizes the inter-area routes on the Dallas router? A. Atlanta(config-router)#area 0 range 192.168.0.0 255.255.252.0 B. Atlanta(config-router)#area 1 range 192.168.0.0 255.255.248.0 C. Atlanta(config-router)#area 0 range 192.168.0.0 255.255.248.0 D. Atlanta(config-router)#area 1 range 192.168.0.0 255.255.252.0 Answer: Option D. Explanation: … Read More »
Why Is The “Value” Focus Area Important To Complete Early On After Launching A New Launch Pad Or Website Initiative? If you don’t first validate that the solution you built does, in-fact, solve users’ pain points and provide value, your team might waste time optimizing something users don’t care about in the first place. The value focus area should be… Read More »