A dispatcher notices that there are a lot of yellow dots within the resource trace route on the map of their technicians.Upon investigation, they find out that their technicians occasionally have to stop for about five minutes to verify the equipment in their truck enlroute to a customer site. It is determined that this Is acceptable behavior and… Read More »
Refer to the exhibit. An engineer is configuring an EtherChannel between Switch1 and Switch2 and notices the console message on Switch2. Based on the output, which action resolves this issue? A. Configure more member ports on Switchl. B. Configure less member ports on Switch2. C. Configure the same port channel interface number on both switches. D. Configure the… Read More »
Refer to the exhibit. An engineer is installing a new pair of routers in a redundant configuration. When checking on the standby status of each router, the engineer notices that the routers are not functioning as expected. Which action will resolve the configuration error? A. configure matching hold and delay timers B. configure matching key-strings C. configure matching… Read More »
Refer to the exhibit. An engineer reconfigures the port-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1’s log: *Mar 1 09:47:22.245: %PM-4-ERR_DISABLE: bpduguard error detected on Gi0/0, putting Gi0/0 in err-disable state Which command set resolves this error? A. SW1(config-if)#interface G0/0 SW1(config-if)#no spanning-tree bpdufilter SW1(config-if)#shut SW1(config-if)#no shut B.… Read More »
A. The dynamic logical profile is overriding the statically assigned profile B. The device is changing identity groups after profiling instead ot remaining static C. The logical profile is being statically assigned instead of the identity group D. The identity group is being assigned instead of the logical profile Answer: Option C. Explanation: No answer description available for… Read More »
Refer to the exhibit. A service provider technician is working on a multicast issue for a customer. While checking the multicast table, the technician notices that no flags are present for the (1.1.1.1, 239.1.1.1) entry, yet flags are present for the (1.1.1.1, 232.1.1.1) entry. Which factor might explain this issue? A. Only the administratively scoped range is permitted… Read More »
Refer to the exhibit. An engineer applied the configuration on R1 to prevent network 192.168.1.0/24 from being propagated outside of area 5. After the change, users have reported they are not able to access any of the application servers that were working before. While checking the routing table of the peer router, the engineer notices R1 stopped propagating… Read More »
A. Fallback is enabled B. Fallback is disabled C. DNS query is disabled D. DNS query is enabled Answer: Option B. Explanation: No answer description available for this question. Show AnswerDiscussion The post An engineer configured a Cisco AireOS controller with two TACACS+ servers. The engineer notices that when the primary TACACS+ server fails, the WLC starts using… Read More »
Sidney Is In Her Google Account, Reviewing Her Campaigns And Attribution Reports. She Notices That The Number Of Total Conversions Reported In The Attribution Report Is Different Than The Number In The Campaigns Report. What Could Explain This? The attribution report doesn’t include website conversions. The attribution report doesn’t include app conversions. The attribution report doesn’t include phone… Read More »
Felix Launched A Google Display Ad Campaign To Drive Sales Of Tools On His Home Improvement Website. After Reviewing Sales Data From The First Week, Felix Notices Higher Sales From Ads That Include A Picture Of The Tool Itself. He Decides To Add Tool Pictures To All Of His Other Ads To Try And Replicate The Success. Which… Read More »